This data is supplied for personal use only. You should also note that the picture images show only our serving suggestions of how to prepare your food - all table accessories and additional items and/or ingredients pictured with the product you are purchasing are not included. Where this description contains a link to another party's website for further information about the product, please note that Wm Morrisons Supermarkets Limited has no control over and no liability for the contents of a 3rd party website. While we have taken care in preparing this summary and believe it to be accurate, it is not a substitute for reading the product packaging and label prior to use. This page serves as a summary for information purposes only, and is designed to enhance your shopping experience on the website. You should note that products and their ingredients (including allergens) are subject to change, so it is important you check the labels and allergy advice of products supplied in each delivery. If the glue thickens or separates, shake vigorously until the original consistency is restored.Īdults need around 2000 kcals a day. Store at room temperature (do not freeze). Not recommended for structural or load-bearing applications, or for continuous submersion or below-waterline use.Ĭlose cap after use. Before finishing, sand surfaces to minimise glue exposure. To remove Gorilla Wood Glue from hands, wash with warm soap and water.Īpplication temperature should be above 13˚C. If tip becomes clogged with dry glue, remove the cap and push the clog backwards with a toothpick, then rinse cap with warm water. Soak hands and skin in soap and warm water, wash, then rinse.Ĭleaning the bottle tip: Use a clean, damp cloth to wipe off excess glue after closing. Wash hands, skin and damp cloths in soap and warm water, then rinse.Ĭlean up when glue has dried: Use a sharp putty knife, razor, or sharp scraper to shave hardened glue from surface, then sand as needed. When areas have completely dried, sand as needed. Make as many passes as needed with the clean area of the cloth to remove all the glue. Note that clamping time can be dependent on temperature, humidity, and the porosity of the wood.Ĭure Time (amount of time for glue to reach total bonding strength): 24 hoursĬlean up while glue is wet: Use a clean, damp cloth to wipe off excess glue. In general, apply enough pressure that will cause a fine bead of glue to squeeze out when the proper pressure is applied.Ĭlamping Time (amount of time pressure needs to remain applied): 20–30 minutes for room temperature applications. The technique and type of clamp to be used is determined by many factors: the specific type of joint, type of stock or lumber, moisture content of stock, room temperature, assembly time and surface quality. Enough glue should be applied so that a fine bead of glue squeeze-out will occur when clamping. Rub together with the other surface to distribute the glue evenly on both surfaces. On hard-to-glue woods, apply the glue on both surfaces. In general, apply a generous amount of glue on one of the surfaces. Just how much Gorilla Wood Glue to apply depends on many factors. Also, be careful to avoid burnishing and end snipes. For laminating, the surfaces should be planed smooth, leaving the board surface free from machine marks, tear-out and snipes. If the glue thickens or separates, shake vigorously until the original consistency is restored.įor best results, it is essential that the wood surfaces are prepared prior to application of glue. Remove clear applicator tip to clean out glue build-up.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |